VALOI Easy35 Half-Frame Holder

The easy35 35mm Half-Frame holder allows you to scan 35mm half-frame film at optimal quality, masking of extra light and shortening the film path for optimal flatness. The holders fits into the easy35 system just like any other compatible holder - by sliding out the existing holder and sliding in this new holder.

The gate dimensions are approximately: Length 21mm Width 25.7mm allowing you to see the whole frame with a small border. 

In use:

VALOI easy35 holders work by passing the film through a thin slit passing through the whole holder and out on the other side. This way, you can conveniently push or pull the film through all the way, saving you time and effort compared to a traditional clam shell holder.

All VALOI holders employ a double-S curve design, where the slit that the film is passed through curves before and after the scanning gate. By bending the film slightly in one direction on both sides of the film, greater flatness is achieved than would be possible with a straight slit. 

Compatibility:

It is compatible with all easy35 units. The holder is conveniently replaced by releasing a single screw screw and pushing the original holder out, and the new one in.